Deck Fastener Quantity Planner

Straight rectangular decking with boards running across supports. The starting values are editable examples, not an approved installation schedule.

Layout assumptions

Boards cross the supports along this direction.

Use the product-specific gap for your conditions.

Counts supports at both ends and intervals no larger than this value. Actual support positions are not designed.

Assumes continuous boards without butt joints, borders, stairs or diagonal runs. Additional supports and joint fasteners require a project-specific takeoff.

Decking fasteners

For shared clips, each interior gap/support intersection is counted once. Start/finish hardware is separate. Confirm your system uses this arrangement; special butt-joint clips or other systems need their own counts.

Method changes load an example rate. Replace it with the product requirement.

Enter verified extra units for details not modeled. Different hardware belongs in the separate list below.

Applied once to the calculated main-item quantity; not to the separately entered hardware.

Use the package label. Package weight does not establish a universal unit count.

For plug systems, use the price for a complete screw-and-plug set.

Separate hardware from the project plan

Enter final purchase counts, including any desired spares. Blank means unknown. These quantities are not inferred from deck size or included in the main-item cost.

Quantity summary

744 face screws

676 before the entered purchase allowance.

26 board rows · 13 modeled support positions · 338 main-item fastening points.

Deck footprint: 192 sq ft.

3 packages, containing 1,050 units.

Edge/start/finish units: Unknown

Joist hangers: Unknown

Ledger fasteners: Unknown

Rim/blocking fasteners: Unknown

This is not a complete hardware list until all project details and separate items have been verified.

Verify the connection and fastening system

Fastener type, corrosion resistance, pilot holes, grooves, spacing and end details depend on the decking, support material, environment and fastening system. Use the product’s current instructions. Ledger attachment also depends on loads, joist span, the house connection and the specified fastener; deck length alone does not establish a screw count.

AWC DCA6 deck guide (2015 IRC basis) illustrates those connection dependencies; confirm the applicable design and local requirements. Trex fastener instructions provide an example of separate system-specific clip and butt-joint details, not a recommendation for other products.

Browse deck fasteners